Hello, everyone.
Well, I got my new laptop yesterday, so now the fun will begin, in terms of
getting it up and running with Jaws, and getting everything put back into
it, including the ARCP programming software, and the N3FJP logging software.
This new computer only has 4 USB ports--no parallel port, no serial ports.
Therefore, I now need advice in terms of what will be required to interface
the TS590 with the new computer.
As for sending CW via the N3FJP logging software, I have contacted the
manufacturer of the parallel interface I used in the past, to see what he
suggests.
But my bigger question now is what do I need in order to use the TS590ARCP
softwre successfully with the new computer?
I clearly will need a USB interface cable of some sort, but don't know what
to order or where to get it.
Also, I know there's a USB driver on the Kenwood web site that I'll have to
download and install, but I understand some folks have had some problems
with that in certain situations.
Therefore, any words of wisdom that anyone can pass along here would be
appreciated.
Thanks, and 73 from Tom Behler: KB8TYJ
|