Assuming that you have set an active partition, check the settings in your
cmos and make sure that the boot sequence is correct and that your drives
are being auto-detected correctly. If your cd-rom is still not functioning
you may need to re-install the driver. Good Luck.
Shawn M. Shea
[log in to unmask]
www.angelfire.com/ca/rockice
>Rebuilding an Acer system(had been upgrading piece at a time and now
putting
>all original pieces back together). It will boot to floppy but will not
boot
>to hard drive. Have fdisk and reformatted disk. Have also installed dos
6.22
>and win 3.11. Still unable to boot to hard drive. I have an AcerPower P60,
>24 m ram, Maxtor 540 HD, CMD IDE controller card.
>p.s. also unable to get it to recognize CD drive. (CD is slave to Maxter)
>TIA
>Rick & Kay McCune
>No Matter Where You Go......
>There You Are!
>
>
>
>
PCBUILD: http://nospin.com or [log in to unmask]