Thanks to everyone who responded to my questions.  I'm not ready to put one
in a vehicle yet but this info will help when I am.

73, Gary-N5GD
    

-----Original Message-----
From: For blind ham radio operators [mailto:[log in to unmask]]
On Behalf Of colin McDonald
Sent: Friday, September 02, 2011 12:50 PM
To: [log in to unmask]
Subject: Re: TM-V71A question

well if the control head cable is 6 pin, then you can't use cat5 because 
cat5 is 8 conducter, and RJ45's are 8 pin.
You have to use that flat telephone or network type cable with 6 conducter, 
and the RJ12 six pin jack...which is the same size as the RJ45, but only has

six pins instead of 8 on the plug.
I would imagine you can probably find shielded 6 conducter cable though just

like you can get shielded 8 conducter which is cat6.

73
Colin, V A6BS
----- Original Message ----- 
From: "Butch Bussen" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Friday, September 02, 2011 8:53 AM
Subject: Re: TM-V71A question


> There have been mixed results using regular cat 5 cable.  Kenwoos uses 8
> pin network cables, rj 45 I think.  Kenwood's over priced cable does have
> the audio shielded.  The network cable is worth a try though.  The 71 uses
> a rj 45 on the radio and a smaller, I think six pin on the control head.
> You could possibly use the short pig tail that comes with the radio and
> adapt to rj 45 cable.  The way Kenwood packages their stuff amazes me.
> They actually make two kits, one has long power cord, long mike and
> control cables but no mounting bracket.  Tlhe $50 one just has bracket and
> control cable.  Go figure!!!
>
> 73
> Butch
> WA0VJR
> Node 3148
> Wallace, ks.