Yup, IC-706 has it in one of the menus I'm about 99% sure.
----- Original Message -----
From: "Gerry Leary" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Friday, March 19, 2010 9:02 AM
Subject: Re: ic-718
> Hmmm, my IC706MKIIG has the control in the Menus.
> ----- Original Message -----
> From: "Butch Bussen" <[log in to unmask]>
> To: <[log in to unmask]>
> Sent: Wednesday, March 17, 2010 11:10 PM
> Subject: Re: ic-718
>
>
>> If you mean the synthesizer board, then they must have changed them.
>> Icom and a e s both say the level adjustment is not on the synthesizer.
>> I even called a e s back and had them ook again and they swear there
>> isn't a level adjust on the board. Very very strange.
>> 73
>> Butch Bussen
>> wa0vjr
>> open Node 3148
>> Las Vegas
>>
>>
>> On Wed, 17 Mar
>> 2010, Anthony Vece wrote:
>>
>>> Yes, the adjustment is on the board.
>>> The 746 pro used the same board.
>>>
>>>
>>> Sent from my iPhone
>>>
>>> On Mar 17, 2010, at 10:04 AM, Russ Kiehne <[log in to unmask]> wrote:
>>>
>>>> The adjustment is on the speech board itself.
>>>> ----- Original Message -----
>>>> From: "tom behler" <[log in to unmask]>
>>>> To: <[log in to unmask]>
>>>> Sent: Tuesday, March 16, 2010 5:55 PM
>>>> Subject: Re: ic-718
>>>>
>>>>
>>>>> Butch:
>>>>>
>>>>> I swear there is an adjustment in one of the menus for UT102 volume.
>>>>>
>>>>> I seem to recall having that problem with mine too, but remember
>>>>> adjusting
>>>>> it. I had to, because it was a rig that I used for Field Day, and
>>>>> often
>>>>> in
>>>>> our motor home, so needed the volume to be a bit higher than usual.
>>>>>
>>>>> 73 from Tom Behler: KB8TYJ
>>>>>
>>>>> ----- Original Message -----
>>>>> From: "Butch Bussen" <[log in to unmask]>
>>>>> To: <[log in to unmask]>
>>>>> Sent: Tuesday, March 16, 2010 5:54 PM
>>>>> Subject: Re: ic-718
>>>>>
>>>>>
>>>>> I did go to a e s and bought the synthesizer and the i-100 tuner. I
>>>>> considred getting the at-100, but they didn't have one in stock and I
>>>>> wasn't sure what the up down manual tuning buttons did and all
>>>>> that, so I
>>>>> figured I'd keep it simple, just one button. On another note, the
>>>>> synthesizer works, but the level seems low. It is fine if you
>>>>> don't have
>>>>> much signal, but it is covered up by the noise unless I turn the rf
>>>>> gain
>>>>> down. Any suggestions? I called a e s and they said no level
>>>>> adjust on
>>>>> the board. I called icom and they are supposed to call me back.
>>>>>
>>>>> Yep, it is a nice little radio, nice for portable or mobile, just a
>>>>> simple
>>>>> little rig.
>>>>> 73
>>>>> Butch Bussen
>>>>> wa0vjr
>>>>> open Node 3148
>>>>> Las Vegas
>>>
>>>
>>
|
