John,

The difference between the settings is timing.  Setting 1 is 10MS, and 
setting 2 is 25MS.  Obviously, use setting 2 if your relay is slow, but if 
setting 1 works, use it.  I think the radio automatically switches to 
setting 1 if you're using full break-in.

Steve

----- Original Message ----- 
From: "John Miller" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Saturday, April 03, 2010 09:41
Subject: Re: TS-2000 questions.


> Yes you will need to turn on the relay. I know there's a 1 and 2 setting 
> for
> it, I don't know the difference, but I use the number 1 setting and it's
> worked fine so far.
> ----- Original Message ----- 
> From: "Rick" <[log in to unmask]>
> To: <[log in to unmask]>
> Sent: Saturday, April 03, 2010 9:28 AM
> Subject: Re: TS-2000 questions.
>
>
>> Thanks, glad to know there's nothing wrong with the radio.
>> I forgot to ask in the last post, will I need to turn the relay on in the
>> menus to use the amp?
>> Thanks again, and 7 3.
>> ----- Original Message ----- 
>> From: "John Miller" <[log in to unmask]>
>> To: <[log in to unmask]>
>> Sent: Saturday, April 03, 2010 9:11 AM
>> Subject: Re: TS-2000 questions.
>>
>>
>>> HF amp connects to the 7 pin connector just below the UHF antenna
>>> connector.
>>> The fan runs quite a bit in the radio but at idle it shouldn't get all
>>> that
>>> hot. warm maybe but not hot though obviously if it's hot in the room it
>>> may,
>>> or if you don't have it vented right.
>>> ----- Original Message ----- 
>>> From: "Rick" <[log in to unmask]>
>>> To: <[log in to unmask]>
>>> Sent: Saturday, April 03, 2010 9:07 AM
>>> Subject: TS-2000 questions.
>>>
>>>
>>>> Hi list.
>>>> Is the fan on the TS-2000 supposed to run allot?
>>>> Even when I'm not using it the fan will kick on and run for a few =
>>>> minutes, then turn off for a few minutes, then kick back on.
>>>> It seems to run more than it's off, and the radio is barely warm, let =
>>>> alone hot.
>>>> Also I'm confused on which connector to plug the Ameritron ARB-704 into
>>>> =
>>>> for my Amp.
>>>> The quick guide says use the cont connector, for HF amplifiers, but the
>>>> =
>>>> manual says used the remote for HF amps.
>>>> And lastly for now, does anybody have a list of the menus they could =
>>>> send me?
>>>> I hate having to wade through the manual every time I want to change =
>>>> something.
>>>> Thanks in advance for any help, and 7 3,
>