Well, Darn, I guess I'll just have to live with it, then.

It's a shame, because it's a good mic, but it gets to be a pain when the 
clip spins around so much.

73 from Tom Behler: KB8TYJ

----- Original Message ----- 
From: "John Miller" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Saturday, May 02, 2009 5:08 PM
Subject: Re: problem with loose rotating clip on back of SMC33 speaker mic 
for THF6A


I have a lot of mics with the same clip, they all come loose after a while,
it's a rivet, so there's not much you can do. Some of them you can take the
rivet out and put another one in or something, but that plastic one, I
wouldn't try it. The old radio shack speaker mics with the metal clip I did
that to.
----- Original Message ----- 
From: "T Behler" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Saturday, May 02, 2009 4:56 PM
Subject: problem with loose rotating clip on back of SMC33 speaker mic for
THF6A


> Hello, all.
>
> I have a Kenwood SMC33 speaker mic for my THF6A, and have noticed recently
> that the little rotating clip on the back of the mic has gotten quite
> loose,
> so that it almost spins freely.
>
> Is this normal for these mics, after extended use, and does anyone know of
> a
> way I can tighten the clip back up again?
>
> Thanks, and 73 from Tom Behler:  KB8TYJ, Big Rapids, MI