Subject: | |
From: | |
Reply To: | |
Date: | Thu, 11 Jun 2009 11:15:40 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
And if you have one of the older ones that doesn't have the CW capability,
John Hansen will upgrade it for a very nominal charge. Danny.
----- Original Message -----
From: "Phil Scovell" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Wednesday, June 10, 2009 10:47 PM
Subject: Re: QSY er
>I wondered. Thanks John.
>
> Phil.
> K0NX
>
>
>
> ----- Original Message -----
> From: "John Miller" <[log in to unmask]>
> To: <[log in to unmask]>
> Sent: Wednesday, June 10, 2009 8:27 PM
> Subject: Re: QSY er
>
>
>> that works with the new ones, not the older ones.
>> ----- Original Message -----
>> From: "Phil Scovell" <[log in to unmask]>
>> To: <[log in to unmask]>
>> Sent: Wednesday, June 10, 2009 9:47 PM
>> Subject: QSY er
>>
>>
>>>I suppose everybody using a QSYer knows this already but I discovered it
>>>by
>>> accident about three months ago. I haven't re read the file of
>>> instructions
>>> sent to me over again to check but I don't recall reading about this.
>>> Pressing the pound key and then tapping key one, two or three, will send
>>> the
>>> frequency in CW. One for MHz, key number 2 for KHz, and number 3 is for
>>> Hz.
>>> I use it sometimes due to noise, or the volume I am listening at. If I
>>> don't want to hear the voice pounding out the frequency really loudly,
>>> or
>>> if
>>> I just want to check the Hz for example, I punch pound and 3 for the CW
>>> frequency and here it sent for Hz.
>>>
>>> Phil.
>>> K0NX
>>
|
|
|