Thanks very much, Mark.

I also have Steve's instructions, so will see which appears to be easiest.

73 from Tom Behler:  KB8TYJ

----- Original Message ----- 
From: "Senk, Mark J. (CDC/NIOSH/NPPTL)" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Wednesday, June 11, 2008 7:21 AM
Subject: Re: setting up scan limits for the TMV71A


> You can restrict the range of the receiver. Here's an excerpt from the
> manual.
> 
> 
> Programable VFO=20
> If you always check frequencies within a certain range,=20
> you can set upper and lower limits for frequencies that are=20
> selectable. For example, if you select 144 MHz for the=20
> lower limit and 145 MHz for the upper limit, the tunable=20
> range will be from 144.000 MHz to 145.995 MHz.=20
> 
> 1 Select your desired VFO frequency.=20
> 2 Enter Menu mode and access Menu 100.=20
> (Example: E type)=20
> 3 Press the Tuning control.=20
> * The lower frequency limit blinks.=20
> 4 Rotate the Tuning control to select your desired lower=20
> frequency limit, then press the Tuning control to set=20
> the selected value.=20
> * The upper frequency limit blinks.=20
> 5 Rotate the Tuning control to select your desired upper=20
> frequency limit, then press the Tuning control to set=20
> the selected value.=20
> 6 Press [ESC] to exit Menu mode.=20
> Note: You cannot program the 100 kHz and subsequent digits. The=20
> exact 100 kHz and subsequent digits of the upper limit depend on the=20
> frequency step size you are using.
> =0C=20
>