I used to have 2 of them, 1 would do it from within memory and the other one
wouldn't. the one that wouldn't though, which is the one I still have, has a
problem with the CPU and doesn't do a couple things it used to do though so
I don't go off that one anymore, I go off what I remember from the one I
sold.
----- Original Message -----
From: "Jim Kutsch" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Friday, August 10, 2007 8:13 PM
Subject: Re: TMG707A Stopped Transmitting
> John and others,
> I knew this list would have the answer. You were exactly correct. The
> rig
> was set to crossband. Pressing function then band brought everything back
> to normal. I'm surprised that the ability to change to crossband mode is
> operational while on a programmed memory channel. So I learned something
> new about the rig.
>
> TNX & 73,
> Jim, KY2D
>
> ----- Original Message -----
> From: "John Miller" <[log in to unmask]>
> To: <[log in to unmask]>
> Sent: Wednesday, August 08, 2007 8:38 PM
> Subject: Re: TMG707A Stopped Transmitting
>
>
> Is it possible the offsets were changed around? Or, maybe the cross band?
> so
> it's transmitting on another band, which can be changed by pushing the
> function button, and the band button. Low beep is normal, high beep is tx
> on
> the other band from where you're listening. Off set is function then rev,
> which is 2 over from the band button. Low beep is simplex, I forget the
> order of the others but cycling through will likely get what you want.
> Otherwise I wonder if there's something done in the menu.
> ----- Original Message -----
> From: "Jim Kutsch" <[log in to unmask]>
> To: <[log in to unmask]>
> Sent: Wednesday, August 08, 2007 8:20 PM
> Subject: TMG707A Stopped Transmitting
>
>
>> CQ TMG707A Experts,
>> I'm reaching out to all of you Kenwood TMG707A operators for some quick =
>> help. I've been digging through the manual but finding no answer.
>>
>> My fairly new Kenwood TMG707A stopped transmitting. I'm using =
>> preprogrammed channels that have worked fine for months. When I push =
>> the PTT, the fan starts, the receiver cuts out, but there's no output at
>> =
>> all. I've verified nothing out by monitoring with another 2M rig. =20
>>
>> This problem started after several front panel buttons were pressed =
>> randomly. It's almost like a transmit lock was activated but if so, I'm
>> =
>> surprised that the fan still starts up. I tried the directions for =
>> keypad lock/unlock but no success. Any ideas what happened and how to =
>> recover? I could do a reset to factory defaults but I hate to lose all =
>> of my frequency and PL programming.
>>
>> Thanks
>> 73,
>> Jim, KY2D
|