excuse my use of the venacula here but I'm shite at building stuff.
can't solder to a board worth a damn.
although I wonder, is there some other way around this slight issue?
Shaun
web sites:
http://www.myspace.com/blindmanshaunoliverhttp://blindman.homelinux.org/~blindman/
skype: brailledude
On 19/05/2008 1:20 AM, the old scribe known as Steve was able to impart
this pearl of wisdom:
> Possibly, but it might cause some issues because of the meter's sensitivity.
> You can tune for max output, but that could result in driving the tubes a bit
> too hard. There are voltage-controlled audio oscillators that one can build
> relatively inexpensively to hook across the meter to give you a direct meter
> read.
>
> Steve, K8SP
> ----- Original Message -----
> From: "Shaun Oliver" <[log in to unmask]>
> To: <[log in to unmask]>
> Sent: Sunday, May 18, 2008 7:32 AM
> Subject: tube radio tuning
>
>
> I had a thought. a rare event I know but there it is.
> earlier, someone made the comment about puttins a piezi buzzer across
> the lead light on an atu.
> could I not put a similar device across the meter on my old yaesu?
> yes there are other solutions out there but I haven't the funding for
> such a venture.
> any thoughts would be greatly appreciated.
>