I have everyone on 1 power supply too here, it works for me, then I have 
another smaller PS in my go kit in case it's needed. I do run my scanner off 
the Astron supply, just to cut back on the outlets used, I'm long past out 
anyway.
----- Original Message ----- 
From: "Brett Winches" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Monday, October 02, 2006 4:36 PM
Subject: Re: question about tm-g707a for Eric Patterson


> No.  the number in the Astron model number refers to the maximum power
> (I think peak) that it will deliver.  If your rig actually needs less it
> will draw less.  The higher output may come in handy if you want to put
> another rig or a power amp on the Kenwood.  I run both my 2/70 m/cm rig
> and my hf rig on an Astron 20 am supply  and may put together a dc cord
> for my scanner though I do not need it in the future.  The draw back is
> that if you are using a set up like mine, I cannot run both rigs in
> different locations at the same time. =20
>
> Thank you!
>
> Brett Winchester - Reading and volunteer Services=20
> IDAHO COMMISSION F/T BLIND & VISUALLY IMPAIRED
> P O BOX 83720
> BOISE IDAHO  83720-0012
> 208.334.3220.104=20
> [log in to unmask]
>
>
> -----Original Message-----
> From: For blind ham radio operators
> [mailto:[log in to unmask]] On Behalf Of Holly Alonzo
> Sent: Monday, October 02, 2006 2:14 PM
> To: [log in to unmask]
> Subject: question about tm-g707a for Eric Patterson
>
> I found a place where I can buy this rig and it doesn't come with a
> power supply to be used kind of as a base station.  do you know what
> kind of power supply I need to get for this?  I found one on ebay its a
> 35a astron or something but my husband said that's too much power and it
> will burn the radio up.  Is this correct?
> =20
> Thanks,
> =20
> Holly
>