My only complaint about the MC-80 is the short goose neck for the mic. You
have to crank the gain way up to get the right amount of audio and then you
get a lot of background noise.
Kevin :)
Amateur Radio: K7RX
-----Original Message-----
From: For blind ham radio operators [mailto:[log in to unmask]]
On Behalf Of John Miller
Sent: Monday, May 14, 2007 14:48
To: [log in to unmask]
Subject: Re: Mc60 mc80 mc85 ...was...RE: changing mike gain on tmv7a
MC-60A, currently sold, does have an amplifier in it but it can be switched
off. The MC80, which I have and love, also has an amplifier, can be adjusted
but you shut it off, you shut off the hole mic, and the MC-85 is pretty much
the same thing but will run up to 3 radios so has a couple more buttons on
it to switch radios, but the basic design is exactly the same as the MC-80
----- Original Message -----
From: "Steve Dresser" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Monday, May 14, 2007 5:37 PM
Subject: Re: Mc60 mc80 mc85 ...was...RE: changing mike gain on tmv7a
> Brett,
>
> All three are desk mics designed to work with Kenwood radios. The
> MC-60A is the only one currently available from stores. Check for
> prices at your favorite store. It has a high/low impedance switch,
> and I think it has a preamp although I'm not sure. The MC-80 doesn't
> have a high/low switch, but it does have a preamp and an adjustable
> gain control on the back of the base. The MC-85 can run two or three
> radios off its multiple outputs.
> I've
> never seen this one, but I've heard it's good. It may have an
> equalizer, but I'm not sure.
>
> Steve
>
> ----- Original Message -----
> From: "Brett Winches" <[log in to unmask]>
> To: <[log in to unmask]>
> Sent: Monday, May 14, 2007 14:44
> Subject: Mc60 mc80 mc85 ...was...RE: changing mike gain on tmv7a
>
>
>> Steve, Can you please refresh me as to what mic is what for these?
>> =20
>>
>>
>>
>> -----
>> BRETT WINCHESTER
>> [log in to unmask]
>> 208-639-8386
>> ###
>>
>>
>> -----Original Message-----
>> From: For blind ham radio operators
>> [mailto:[log in to unmask]] On Behalf Of Steve Dresser
>> Sent: Monday, May 14, 2007 12:03 PM
>> To: [log in to unmask]
>> Subject: Re: changing mike gain on tmv7a
>>
>> Tom,
>>
>> The MC-60A will work. So will an MC-80 (which is what I use), or an
>> MC-85.=20 In the case of the latter two mics, you'll have to buy them
>> used.
>> You'll also have to get an adaptor to go from the Kenwood 8-pin
>> connector to an RJ45, but those adaptors are readily available from
>> any good ham radio store.
>>
>> Steve
>>
>> ----- Original Message -----
>> From: "T Behler" <[log in to unmask]>
>> To: <[log in to unmask]>
>> Sent: Monday, May 14, 2007 11:52
>> Subject: Re: changing mike gain on tmv7a
>>
>>
>>> Steve:
>>>
>>> That desk mic idea actually sounds like a possibility. ... I have
>> three
>>> TMV7A's and had actually thought of swapping one of the others out,
>> and
>>> putting it into the RV for our trip.
>>>
>>> I know the others don't have this problem.
>>>
>>> Then, I could just pick up a desk mic somewhere and use it with the
>> hot=20
>>> one
>>> at home as the base unit.
>>>
>>> Any recommendations on a desk mic that would fit the TMV7A?
>>>
>>> 73 from Tom Behler: KB8TYJ
>>>
>>> ----- Original Message -----=20
>>> From: "Steve Dresser" <[log in to unmask]>
>>> To: <[log in to unmask]>
>>> Sent: Monday, May 14, 2007 11:15 AM
>>> Subject: Re: changing mike gain on tmv7a
>>>
>>>
>>>> Tom,
>>>>
>>>> If you use a desk mic with a gain control, you don't even need to
>> worry
>>>> about whether there's a gain control on the radio. Alternatively,
>> you
>>>> might
>>>> be able to get someone to build you a box with a 10000 Ohm pot to
>>>> do
>> the
>>>> job. I know these aren't good solutions for using the radio in a
>> mobile
>>>> environment, but they would work nicely for a base rig.
>>>>
>>>> Steve
>>>>
>>>> ----- Original Message -----=20
>>>> From: "T Behler" <[log in to unmask]>
>>>> To: <[log in to unmask]>
>>>> Sent: Monday, May 14, 2007 08:24
>>>> Subject: Re: changing mike gain on tmv7a
>>>>
>>>>
>>>>> Colin and all.
>>>>>
>>>>> Well, this is interesting, and I'll let you guys know what the
>> Kenwood
>>>>> tech
>>>>> says in response to my inquiry.
>>>>>
>>>>> What Colin is saying makes sense, but at the same time, I find it
>>>>> interesting that a company would make a radio that you can't
>>>>> control
>> the
>>>>> mic
>>>>> gain on.
>>>>>
>>>>> Although, come to think of it, HT's are that way--what you hear is
>> what
>>>>> you
>>>>> get.
>>>>>
>>>>> Anyway, will keep everyone posted.
>>>>>
>>>>> 73 from Tom Behler: KB8TYJ
>>>>>
>>>>> ----- Original Message -----=20
>>>>> From: "Colin McDonald" <[log in to unmask]>
>>>>> To: <[log in to unmask]>
>>>>> Sent: Monday, May 14, 2007 6:13 AM
>>>>> Subject: changing mike gain on tmv7a
>>>>>
>>>>>
>>>>>>I would beg to differ regarding an internal pot for the mike gain
>>>>>>on
>> the
>>>>>>tmv7a.
>>>>>> If there are any internal pots at all, they control other
>> functions.
>>>>>> The
>>>>>> audio
>>>>>> gain, both receive and transmit are both controlled by the micro
>>>>>> processor and not controlled by an analog device. For instance
>>>>>> when you use the microphone remote control feature, and use the
>>>>>> volume and squelch adjustment buttons, the radio adjusts those
>>>>>> functions, and as soon as you go to adjust them again on the
>>>>>> radio, it will default back to what ever it was before you
>> started
>>>>>> adjusting from the microphone. If there was an internal pot that
>>>>>> controlled either audio or squelch, this could not be
>>>>>> accomplished the way it
>> is.
>>>>>> The
>>>>>> same holds true for the tx audio. Since there is an option
>>>>>> within
>> the
>>>>>> service
>>>>>> menu to adjust the tx audio, it wouldn't then also have an
>>>>>> internal
>> pot
>>>>>> to
>>>>>> adjust since the internal processor is already controlling
>>>>>> that=20 function nicely.
>>>>>> There are likely surface mount components that could be altered
>>>>>> to adjust the gain, in other words, the various information being
>>>>>> sent to the processor.
>>>>>> 73
>>>>>> Colin, V A6BKX
>>>>>>
>>>>>
>>>>>
>>>>>
>>>>
>>>
>>>
>>>
>>
>>
>>
No virus found in this incoming message.
Checked by AVG Free Edition.
Version: 7.5.467 / Virus Database: 269.7.0/803 - Release Date: 5/13/2007
12:17
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.5.467 / Virus Database: 269.7.0/803 - Release Date: 5/13/2007
12:17
|