Fred,

Not sure  what  is going on at your end, but remember the 2000 has a main
and a sub receiver and  on the main receiver has  two VFO's  A and B.

To switch between a and b  vfo's, use a/b button.  To  change between main
and sub rx, use the left and right  buttons of the  four buttons just to
the right of the main tuning  knob.

If the problem is on the sub rx, be sure it  is turned on by pushing in the
sub volume control, which is the knob at the lower right hand corner of the
front panel.

If you can't rx on the main, be sure the  rf gain is fully clockwise.    It
is the outer ring of the knob just to the left of the  multi  function knob.

To do a full reset:
1. Turn off rig.
2.
 Press and hold a/b button  while turning on  power
3  After rig comes on, release a/b button
4 Press a/b button  again and rig will reset.  If you don't push the a/b
button  a second time within a few seconds, the reset will abort and not
take place.  It is sort of giving you one last chance to change your mind
before it's too late.

Same instructions for a partial reset except use a=b button instead of a/b
button.  Full reset  restores rig to the way it was  when you opened the
box.   Partial reset leaves memories and menus intact.

Good luck, Steve KW3A

----- Original Message ----- 
From: "Fred Olver" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Sunday, March 26, 2006 8:32 AM
Subject: ts2000 question


> Morning guys,
>
> I find the a rcvr in my ts2k wants to rcv but does not, I tried toing a
> partial and full reset but in reading the manual can't tell the difference
> in what is to be done, also, the radio is transmitting on the a rcvr, but
> not rcving, this is true, at least on the two meter bands and 440
megahertz
> bands.  Also, think may have changed the rx so that the a rcvr is the b
> rcvr, how to change back?
>
> Fred Olver  [log in to unmask]
>
>
>