Jeff:

I guess that's what I meant to say in my earlier post, but it was early in
the morning, and the brain wasn't quite functioning fully yet.  HI!  HI!

73 from Tom Behler: KB8TYJ

----- Original Message ----- 
From: "Jeff Kenyon" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Tuesday, June 20, 2006 11:21 AM
Subject: Re: entering FRS freqs into THF6A solved


> You actually would enter in 462.562 and thn move a click to your right.
>
>
>
>
>
> On Tue, 20 Jun 2006, T Behler wrote:
>
> > Hi, all.
> >
> > I just wanted to let everyone know that I have solved the FRS frequency
> > entry problem with the TH
> > F6A.
> >
> > As it turns out, what I have to do is enter the frequency I want on the
> > keypad, and then use the tuning knob to "fine tune" things.  It does
seem to
> > work best if the tuning step is set to 12.5 KHZ.
> >
> > So, if I enter 462.5625 on the keypad, and then click the tuning knob
one
> > click to the right, I'm where I need to be.
> >
> > Kind of "round about", but it does work.
> >
> > Obviously, I might need sighted assistance to be sure I'm actually
there.
> >
> > The other thing I'll probably do is put all of the FRS frequencies into
> > memory channels;  that way, I won't have to worry about anything other
than
> > getting the proper memory channel.
> >
> > Thanks to all on the list for putting up with the rather long thread on
> > this, but we finally have it solved.
> >
> > Vy 73 from Tom behler: KB8TYJ
> >
>