Hi Patrick,
This error could be due to several things including a hardware failure,
incompatible hardware, or a BIOS failure. Try removing or disconnecting all
hardware not related to the basic operation of the computer such as modems,
sound cards, hard drives, CD-ROM, printers, etc. Don't rule out the power
supply, especially if it's low powered and additional hardware has been
added. Try reseating all components and connections and insure all cooling
fans are operational.
Also check or replace the CMOS battery. Replacing the battery will reset the
BIOS to default or you can reset it manually via the jumper. Consult the
computer or board manual for instructions on your model. The jumper is
usually located close to the CMOS battery. Disconnect the power supply
connector at the board. Usually there are three pins with the jumper on two
of them (short) and a visible (open) pin. Place the jumper on the open pin
and the one next to it for about five seconds, then move it back to it's
original default position. Reconnect the power connector.
Contacting technical support of your system or motherboard manufacturer may
provide additional information. If the problem is a BIOS failure, the chip
would have to be sent to the manufacturer for reprogramming or replacement.
Here is a site with more information that may be helpful:
Troubleshooting the Motherboard - General Failures:
http://www.pcguide.com/ts/x/comp/mbsys/genFailure-c.html
Sven Swanson, Sr.
----- Original Message -----
From: "Patrick Macaspac" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Wednesday, October 05, 2005 9:31 AM
Subject: [PCBUILD] MoBo Issue
I have a DFI Mainboard and had a 256Mb RAM (SDRAM). My Local User account
was corrupted and decided to backup my files, etc... So I can begin
reformatting the hard drive, with the use of a startup dick, the hard drive
was reformatted and I was ready to install the OS. I used a bootable WIN XP
CD. The CD seems to be scratched but I used it anyway, when it was copying a
.cab file, the installation was stucked. I ran the OS installation again and
the same scenerio happened. I went to my neighbor thinking that maybe ha can
help me, when we restarted the system, the following message appeared: BIOS
Checksum Error. From then on, I was unable to start the system. Is my BIOS
damaged now? Can anyone help me on this one?
Do you want to signoff PCBUILD or just change to
Digest mode - visit our web site:
http://freepctech.com/pcbuild.shtml
|
