Hi.
Place again the hd on the Pentium mobo, and write down the geometry
after hdd recognition. Then make sure you have the same geometry on the 486.
geometry=c/h/s
>
> This drive was previously on a Pentium mobo, now when i bring it to a
> 486, it doesn't load windows. It is a western digital 730mgs (master in both
> cases) I must say the bios takes it only as a 696mgs.
>
> 486 is a local bus mobo and at least the floppy part of the controller is
> working ok.
>
> Any help would be appreciated.
> Jaime
>
> --
>
************************************
Javier Vizcaino. Ability Electronics. [log in to unmask]
Starting point: (-1)^(-1) = -1
Applying logarithms: (-1)*ln(-1) = ln(-1)
Since ln(-1) <> 0, dividing: -1 = 1
(ln(-1) is complex, but exists)