Subject: | |
From: | |
Reply To: | |
Date: | Wed, 14 Jul 2004 15:51:58 -0700 |
Content-Type: | TEXT/PLAIN |
Parts/Attachments: |
|
|
You have to turn on the mike in the menu as I recall. Here is what little
I have written down on it. I can't remember if I clipped this out of the
menu or where...
REMOTE MICROPHONE CONTROLLER
If you have a DTMF microphone, you can use the
microphone as a wired remote control unit as
described below.
1. Plug the DTMF microphone into the microphone
connector of the transceiver.
2. Press [MENU], then turn the MULTI/CH control to
access Menu No. 45D.
3. Press [+] to select ON.
4Press [MENU] to store the setting and exit Menu
mode.
The DTMF keys function as follows:
DTMF key
Function
FUNC mode
1
Scan
-
2
Tone/CTCSS/DCS
Code Select
3
REV
SHIFT
4
MHz
-
5
MONI
Lock ON **
6
Voice 1
Lock OFF **
7
Volume* Up/Down
-
8
Band* Up/Down
-
9
Squelch* Up/Down
-
0
PWR* Up/Down
-
A
ENT
-
B
CTRL
Main/Sub
C
Repeater
-
D
FUNC
Func OFF
*
Down
Down
#
Up
Up
* Use the [#] (Up) and [*] (Down) keys to change the settings of these
functions.
* *The LOCK function is for the microphone keypad
Note: Microphone Remote does not function while transmitting.
You can use the D TMF Memory function {page 75} with the
Microphone Remote function.
The Repeater function is available for K-type models only.
Normally, pressing [2] cycles through Tone, CTCSS, DCS, and
OFE However, if 1750 Hz is selected for Tone, pressing [2] will
only transmit the 1750 Hz tone. To return to Tone/ CTCSS/ DCS
mode, you must first deselect 1750 Hz for Tone.
Press [D] to enter FUNC mode, to use the 2nd function of the
DTMF keys. Pressing [D] while in FUNC mode will exit FUNC
mode.
[FUNC] on the transceiver works independently from the
Microphone Remote [FUNC] key.
73s
Butch Bussen
wa0vjr
|
|
|