You're right, the band width is only receive.
----- Original Message -----
From: "Don Bishop" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Thursday, May 27, 2004 12:37 PM
Subject: Re: THF6A mic gain setting?
> Steve,
>
> I thought the mode change was a receive-only change.
>
> Maybe I'm wrong, but I don't recall seeing anything in the manual about
mode changes to the transimtter.
>
> Don W6SMB
>
> On Thu, 27 May 2004 12:25:41 -0400, Steve Dresser wrote:
>
> Tom,
>
> You'd probably have to look at a schematic to find the adjustment,
assuming
> there is one. Before you do that, you might want to check to see if
you're
> in narrow band mode. That's a menu setting, and changing it to wide may
> give you a bit more gain. I don't remember which setting it is, but I'll
> research it if you want me to.
>
> Steve
>
> On Thursday 5/27/04 11:49 Tom Behler wrote:
>
> >Hi, all.
>
> >Does anyone know if the mic gain can be adjusted on the Kenwood THF6A HT?
>
> >I have been consistently getting reports that the audio on my THF6A is
much
> >lower than some other Ht's I have, like the HTX202 and 404, and wonder if
I
> >could adjust the mic gain on the THF6A to make things more equal.
>
> >People tell me that my signal is strong; it's just that the audio is low.
>
> >I can't seem to find a mic-gain adjustment in the manual, although I
haven't
> >had lots of time to spend looking.
>
> >Thanks, and best 73 from Tom Behler: KB8TYJ
>
|