Subject: | |
From: | |
Reply To: | |
Date: | Wed, 17 Nov 2004 00:30:14 -0500 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Hi Fred.
You do not actually want to perform impedance transformation with the
balun, as the ladder line is actually doing that for you, so a 1 to 1
should do the job. Personally, I've run them without a balun. In fact, my
last balun got struck by lightning and I ran the coax straight into the 450
ohm ladder line with no balun when I put the antenna back up, and it works
fine. I would, however, echo the comment about being certain to use stand
offs when bring the ladder line down the tower.
73, de Lou K2LKK
At 11:35 PM 11/16/2004 -0500, you wrote:
> I would appreciate some suggestions on putting up a G5RV antenna. I have a
>new g5rv antenna that I have had for years but never used and it is very
>perfessionally made. I can put it up about 40 feet on a roan tower in an
>inverted V configuration with the apex facing south. Do I need to use a 1 to
>1 balun to go from 450 olm ladderline to RG213 coax? I have 58 feet of RG213
>coax with the PL259's already soldered on that I want to use. I would have
>to use a barrall connector if I have to extend the 58 feet of coax. Is a 1to
>1 balun what I need to go from ladderline to RG213 or do I need something
>else. I don't care to get into a lot of detail here, I just want to put up
>an antenna that works fairly well from 10 to 40 meters.I tried a g5rv once
>before without much success and I believe it was because of not enough coax
>and maybe the wrong balun. I will appreciate any suggestions.
>
>Best Wishes,
>
>
>FRED ADAMS W4HC
>FIGHT TRUTH DECAY
Louis Kim Kline
A.R.S. K2LKK
Home e-mail: [log in to unmask]
Work e-mail: [log in to unmask]
Work Telephone: (585) 697-5753
|
|
|