Sender: |
|
Date: |
Fri, 5 Dec 2003 18:40:19 -0800 |
Reply-To: |
|
Content-type: |
text/plain; charset=US-ASCII |
Subject: |
|
MIME-Version: |
1.0 |
In-Reply-To: |
|
Content-transfer-encoding: |
7BIT |
From: |
|
Parts/Attachments: |
|
|
Master and slave jumper settings are specific to IDE/EIDE/ATAPI type
interfaces.
SCSI assigns each device an ID (0-7 for narrow SCSI, 0-15 for wide). The
controller is usually device 7, and it's normal to have the boot drive be
device 0. (Some controllers let you change that, some don't.) The devices
are all connected, in (more or less) any order, to a bus which must be
"terminated" at each end. Controllers and some drives have termination
circuitry on board that can be enabled by a jumper or configuration; for
those that don't, separate terminator units can be plugged into the lat
connector on the bus.
But since these systems have already been used, the hardware configuration
*should* already be in a working state.
David Gillett
On 5 Dec 2003 at 10:17, Heath Purdy wrote:
> take a look at the hard drive and cd rom and make sure they are set at the correct jumpers master, slave etc.. Then look in the bios to see what the bios has them set at.
>
> > -----Original Message-----
> > From: William Pike [mailto:[log in to unmask]]
> >
> > If FDISK can see the drive then you can install the OS on it.
> >
> > -----Original Message-----
> > [mailto:[log in to unmask]]On Behalf Of John Hudson
> >
> > Heres the catch I have never had any luck installing an os onto a
> > system that has a a scsi drive this particular system does not read
> > the HD or cd rom which will pick up in my non scsi machine. Any
> > Ideas as to how I can get this white elephant to get out of the door
PCBUILD maintains hundreds of useful files for download
visit our download web page at:
http://freepctech.com/downloads.shtml
|
|
|