Sender: |
|
Date: |
Tue, 17 Dec 2002 10:07:31 -0500 |
Reply-To: |
|
Subject: |
|
MIME-Version: |
1.0 |
X-cc: |
|
Content-Transfer-Encoding: |
7bit |
Content-Type: |
text/plain; charset="iso-8859-1" |
From: |
|
Parts/Attachments: |
|
|
Just run a wire from a "side" mounting screw on the drive to the computer case,
(or any other mounting screw holding another device). I can NEVER think of a
reason for a normal user to solder on (or near) a Hard Drive.
The mat seems fine for limiting movement, and protecting the drive from bumps
and bangs, BUT --- I would think the "mat" would act as a good insulator of heat.
One thing you do not want to do is insulate a hard drive so it has heat build-up.
Some HD manufacturers go so far as saying to NOT place paper stickers on HDs
(for identification) since even *that* can interfere with cooling. YMMV, and people
will (and do) have different opinions on how carried away with all this you "need"
to get...
PS: I once destroyed an HD by having it *flip* from standing vertical (on its side) to
horizontal, (A movement of 90*), so be REAL careful moving a loose drive around.
(It was "not running" at the time it "fell"...)
Rick Glazier
From: "Goran Halfvarson" <[log in to unmask]>
> I have a disk laying in the bottom of the case.
>
> You say grounding is a good idea: How should I attach a grounding cable? Do
> I have to use my soldering pen?
>
> Btw, I have put the disk on a piece of plastic friction mat (intended for
> use in kitchens) to make sure the disk does not move around.
Rick Glazier sdaid:
> > A "system" used by some is to just leave the Hard Drive laying in the
> > bottom of the case, and NEVER move or disturb the case...
> > There have been discussions about if it is necessary to manually bond
> > the drive to the case ground electrically... It is always a
> > good idea...
Do you want to signoff PCBUILD or just change to
Digest mode - visit our web site:
http://freepctech.com/pcbuild.shtml
|
|
|