Subject: | |
From: | |
Reply To: | |
Date: | Sat, 25 Jan 2003 08:05:32 -0600 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
In addition to checking for bent pins on the video cable plug, also check for loose pins. I worked on an old IBM that had a couple of loose pins. If I connected the monitor normally to the computer it wouldn't work. If the plug was turned upside down, the pins stayed straight. On a hunch, I turned the computer to match the plug orientation and connected them. That did the trick. Everything worked when the computer was booted.
Jim
--------------------------------------------------------------------------------
Date: Thu, 23 Jan 2003 22:57:15 -0500
From: Paul Ecclestone <[log in to unmask]>
Subject: No video
I have 2 computers and a known to be good monitor. Both computers (486's)
all of a sudden give no video signal. It would seem very unlikely that
they both would have a video card go bad at the same time. The monitor is
original to the computer. The computers were not hooked up for awhile -
hence no electrical surge would explain. Would a possible dead battery
cause this? I suspect not, but...
When firing them up, the monitor light comes on for a second, turns
orange, then shuts off. Nothing makes it to the screen.
Regards,
Paul Ecclestone
The NOSPIN Group Promotions is now offering
Mandrake Linux or Red Hat Linux CD sets along
with the OpenOffice CD... at a great price!!!
http://freepctech.com/goodies/promotions.shtml
|
|
|