Subject: | |
From: | |
Reply To: | |
Date: | Sun, 1 Dec 2002 16:31:03 -0500 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
David Gillett wrote:
> On 30 Nov 2002, at 10:21, Jose E. Dominguez wrote:
>
> > For reasons only known to the manufacturer, the connection is BNC. It
> > doesn't look like its a NIC that can be changed, not that I'm going to
> > open it up and try it, this thing cost $250,000 and is as big as a
> > house.
> >
> > I thought with a BNC converter I could just connect the PC to the cutter
> > with a crossover cable. Problem is the converter will not work with a
> > crossover cable. I'll have to use a hub or find a PCI NIC that has BNC
> > connector on it.
> >
> > Jose
>
> I had assumed that your requirement was something like this. As far as I
> can determine, a balun is not going to do the conversion you need.
>
> Since 10Base-2 (co-ax w/BNC) is limited to 10 Mbps, most NICs so equipped
> are still made for ISA slots. Might consider dedicating an old machine to
> run as a dedicated router (Linux or NT can do this) between an ISA 10Base-2
> NIC and a 10Base-T (or 100Base-TX) [ISA or PCI] NIC -- it's overkill, but
> not necessarily more expensive than any other option.
Thanks, didn't think of that. I might just have to do this if they decide one
day to have all three cutters connected together.
Jose
The NOSPIN Group provides a monthly newsletter with great
tips, information and ideas: NOSPIN-L, The NOSPIN Magazine
Visit our web site to signup: http://freepctech.com
|
|
|