Subject: | |
From: | |
Reply To: | |
Date: | Sun, 25 Mar 2001 20:00:01 -0500 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
From: William Patton
Date: March 25, 2001
Subject: Installation of Promise ATA 100 Controller
I recently installed a 20 gig HD into my system, which is an Asus MB,
200MMX, HX chipset. I used the EZ Bios software and everything has been
fine. Today I installed a Promise ATA 100 controller card so that I could
place the 20 gig drive on that and remove the EZ software. I installed the
card and drivers separately (without the hard drive) and everything went
fine. I have Win98SE, and the drivers installed form disk and the
controller is recognized in device manager and no conflicts. I then
rebooted to be sure everything was fine, which it was. I then shut down and
placed the 20 gig drive on the controller card being careful to set the
jumper for single drive and installing the special cable properly with pin 1
in pin 1 at both ends. When I boot the controller bios shows the hard drive
attached now, however, it does not come up anymore in Windows Explorer.
Any help would be greatly appreciated. Thank you , William Patton
_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com
The NOSPIN Group provides a monthly newsletter with great
tips, information and ideas: NOSPIN-L, The NOSPIN Magazine
Visit our web site to signup: http://freepctech.com
|
|
|