Mime-Version: |
1.0 |
Sender: |
|
Subject: |
|
From: |
|
Date: |
Wed, 14 Jun 2000 21:59:25 -0400 |
Content-Type: |
text/plain; charset="us-ascii"; format=flowed |
Reply-To: |
|
Parts/Attachments: |
|
|
Don,
I was fortunate in obtaining an installation and user guide from Imation
Canada. Here is what it says about the cable installation,
12 " Attach the supplied IDE cable to the rear of the SuperDisk drive.
Make sure Pin 1 (identified by the red stripe or marking) on the cable
is on the side closest to the power connector. Holding the SuperDisk
drive right side up with the rear of the unit facing you, the red wire
should be on the right side of the cable. When positioned correctly,
you should not need to force the connection but will feel a
slight resistance
followed by a slight click. DO NOT use the the floppy drive cable
supplied with your
computer.
After you have successfully attached the supplied IDE cable to
the SuperDisk drive, plug the other end of the IDE cable into an
available IDE connector(often, but not always, located on the
motherboard).
I hope this helps.
George
Do you want to signoff PCBUILD or just change to
Digest mode - visit our web site:
http://nospin.com/pc/pcbuild.html
|
|
|