Subject: | |
From: | |
Reply To: | |
Date: | Tue, 14 Mar 2000 07:02:56 -0800 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Two things to check out right away. Does the Adaptec card diagnostics
recognize the drive? You can enter the diagnostics by pressing control-A
during the boot process. Also to check are the cable connections. With
heat/cool cycling that a computer goes through, the connections at some
point can go bad. Unplugging the SCSI cable and plugging it back into a
device often will solve a connection problem.
If none of this helps, try to determine if the controller or drive is
causing the problem. A bad drive would require data extraction by a data
recovery company - an expensive proposition. From what you described,
however, I would expect that you can get the system running for at least
long enough to recover the data.
I had an older SCSI drive of mine go out that way recently. I nursed it back
temporarily, but then had to do a low-level format. It worked after that,
but I was not willing to give it my full trust. Since it was only a 1G size
(high when I got it, but low by today's standards), I put it out of service.
Good luck in your efforts.
Peter Shkabara
_______________________________
[log in to unmask] <mailto:[log in to unmask]>
http://pesh.what.cc
-----Original Message-----
I have had a SCSI drive for over 4 years now and a few days ago, it simply
failed to be recognized by my adaptec scsi controller. Just like that!! I
had simply closed my computer like I usually do, and next day, when I opened
it, dead.
I hear the hard disk spinning, but then I don't hear the writing process
that I usually hear. I then get the message "failed to read".
Since I had precious data on it, is there a way to move the data onto
another disk?
PCBUILD's List Owner's:
Bob Wright<[log in to unmask]>
Drew Dunn<[log in to unmask]>
|
|
|