Hi,
This is not really a multi-boot problem, I guess, but a hardware
detection problem. I mentioned the multi-boot just to round out
the description.
I have SP-3 installed. Always have, and always reinstall it after
any change. No joy. Not sure what you mean by SB below. Can
you clarify? My jukebox is on the secondary IDE, I believe. At
any rate, SP-3 is not the answer. :(
Lance
On Mon, 30 Mar 1998 09:01:19 +0000, [log in to unmask] wrote:
> Hi.
> I ran into a multi boot problem with NT4. For it too work
> completely, I had SP3 installed, and since I was using the CD at
> the IDE of a SB, I changed this last to quaternary (168+, 36E and
> IRQ10); there are reasons to do so. If your jukebox is at an
> IDE not primary/secondary, you can go this way, or at least try
> SP3, which I think is more debugged.
>
> >
> > I run a quad-boot box. P5-120 with the Sanyo
> > 3-cdrom jukebox.
> >
> > When I come out of NT4.0, I get an "ATA Disk Change --
> > press any key to continue" message. This throws me
> > into my BIOS setup (Mr. Bios), and the ATA Disk shows
> > Lance
>
|